• Print
• .

PA110

PA 1-10 (Updated 05/19/2016)

Test Frequency : 13.5 MHz TOMCO serial number 6166 0.1-30 MHz
WERLATONE serial number 96394 1-30 MHz
FILTER serial number 0001 13 MHz (*doug williams)

Settings

• AUTO DHCP - ok
• FRONT LED - ok; when no load, LED OFF - ok
• default db in = 1dBm

Power Supply Measurements

AC voltage setting: 115 V
DC voltage (V): 26.5
Ammeter reading: 1.6 A
UPS power load w/ 2dBm input(W): not available

Updates: 10k Ohm on C3, Rabbit Firmware: 05/19/2016

Signal Measurements

• RF power meter: Mini Circuits PWR-SEN-6HS+ USB power sensor
• internal attenuator set at 0 dBm
• power meter 50 dBm offset applied for measurements at Tomco output and rear panel connectors

Temperature Measurements

• temperature meter: DM6802B Digital Thermometer

(old Notes)

• TOMCO serial number xxxx
• Configured for 16.3 MHz

Power Supply Measurements

AC voltage setting: 115
DC voltage (V): 24.0 (should be about 24.5 V under load, adjust otherwise)
Ammeter reading (A): 1.3
UPS power load w/ 2dBm input(W): N/A

Signal Measurements

• RF power meter: Mini Circuits PWR-SEN-6G+ USB power sensor
• internal attenuator set at 0 dBm
• power meter 50 dBm offset applied for measurements at rear panel connectors
• 10 dB attenuators used at FWD and RFL outputs to achieve 50 dB atten of actual signal

Temperature Measurements

• temperature meter: DM6802B Digital Thermometer

Spectrum Analyzer Images

Input Signal

At FWD connector

At RFL connector

At OUT connector