• Print
• .

Hardware required to assemble radar enclosures (8-channel)

All hardware A2/304 or A4/316 stainless unless specified.

Boards

• 2x VICOR Boards
• 1x POWER DISTRIB
• 1x ANALOG BACKPLANE
• 1x LO BACKPLANE
• 1x LO DISTRIB
• 8x QRX Receiver
• 8 ACTANTENNA

Quantities for each RX BOX

VICOR HEAT Plate with

• VICOR stacks (2 for 8 Channel master; 1 for 8 Channel slave), for each
  • 1 QTY EMI Gaskets, Sheets, Absorbers & Shielding EMI Shields
  • 1 QTY Isolated DC/DC Converters C 9/36/28 15v/ 6.67A
  • 1 QTY 4.991 kohm 1206 Resistor for rdown to set voltage down to 12.5 Volts from 15 Volts
• 2 QTY 12" VICOR cable twin connector (2 red/2 black)
  • 1 EACH Ferrite Clamp On Cores Round 9mm Cable Clamp Filter
  • 1 EACH for black red Molex 19146-0035 Block Fork Terminal, #6 Stud, 16-14 AWG
  • 1 EACH Mini-Fit Jr. Series, Receptacle, 6 Positions, 4.2 mm
• 1 QTY PER VICOR BOARD INPUT TERMINAL CONNECTOR (2017 only)
  • 1 EACH 7" Black [14-16AWG #6 Spade Terminal non-insulated >---< 14-16AWG #6 Spade Terminal] (2017 only)
  • 1 EACH 8" Red [14-16AWG #6 Spade Terminal non-insulated >---< 14-16AWG #6 Spade Terminal] (2017 only)
• 6 QTY m3 washers
• 6 QTY m3x20mm screws
• 6 QTY M3 x 9mm CLEARANCE BRASS 4.75mm O/D

DTACQ MOUNT

• 4 QTY Vibration-Damping Sandwich Mount with Stud and Insert
• 2*4 QTY M-4 screws
• 1 QTY FAN GUARD 60MM WIRE MESH NATURAL

CONNECTOR Plate 2021

• 9 QTY SMA bulkhead Female to N Female
• 1 QTY Amphenol CONN RCPT MALE 4P GOLD SLDR CUP (for 2017: substitute with UHF F-F bulkhead)

TOP_SECTION BASE PLATE

• DTACQ
• Fan Assembly
  • 1 QTY DC Fans 12Vdc 1.3W 16.3CFM DC Axial 60x60x10mm (cable twisted)
    • 4 QTY F-344-8012 BLACK FAN MOUNT
    • 1 QTY Headers & Wire Housings REC 02P CLOSED END
  • 1 QTY DC Fans DC Fan, 80x25mm 12VDC, Vapo, MagLev (cable twisted)
    • 4 QTY F-345-8 FAN MOUNT
    • 1 QTY FAN GUARD BLND HL MNT BLACK 80MM
    • 14" cable extension 24AWG black/red
    • 1 QTY Headers & Wire Housings REC 02P CLOSED END (cable twisted)
• LO distribution Board
  • 2 QTY CONN TERMINATOR PLUG SMA 50OHM
  • 2 QTY MCX to SMA adaptor
• Power Distribution Board
  • 1 QTY 2" POWER DISTRIBUTION HEADER for Active Antennas 14-16AWG #6 Spade Terminal non-insulated >---< [14-16AWG #6 Spade Terminal non-insulated (2017 only)
  • LO Backplane Power Cable (3 Black, 5 red)
    • 2 QTY Mini-Fit Jr. Series, Receptacle, 8 Positions, 4.2 mm
    • 1 QTY Ferrite Clamp On Cores Round 13mm Black Cable Clamp Filter
  • LO DISTRIBUTION Cable Power Connector (1 Red, 2 Black) (2017 only)
    • 2 QTY Mini-Fit Jr. Series, Receptacle, 4 Positions, 4.2 mm
    • 1 QTY Ferrite Clamp On Cores Round 7mmUSB Black Cable Clamp Filter
  • DTACQ Cable Power Connector
    • 1 EACH Mini-Fit Jr. Series, Receptacle, 6 Positions, 4.2 mm
    • 11" DC Power Connector
    • 2 PCS Socket, Crimp, 22 AWG, Tin Plated Contacts
    • 1 QTY Ferrite Clamp On Cores Round 4mmUSB Black Cable Clamp Filter

RXBASE PLATE

• 10 QTY ID=4mm x H=5.5m OD=8mm nylon spacers
• 10 QTY m3 washers
• 12 QTY m3 x 12 mm flat head Phillips screws
• 2 QTY ID=4mm x H=7.5mm OD=8mm nylon spacers
• 74 QTY m3 x 3mm/4mm flat head Phillips screws
• 16 QTY 13/16" Board spacers for dlw filter

SIDE CHANNEL LEFT PLATE Fan Assembly

• 1 QTY DC Fans Fan, 120x25mm, 12VDC Vapo, Auto Restart
  • 4 QTY Ultra Soft Anti-Vibration Fan Mount
  • 1 QTY FAN GUARD BLND HL MNT BLCK 120MM
  • 1 QTY Headers & Wire Housings REC 02P CLOSED END

Cables and Connectors

• 1 QTY 5ft UHF (PL-259) Male cut to 30" + 10" RED/BLACK connector 2 PCS Fork Terminal, #10 Stud, 12-10 AWG + Ferrite Clamp On Cores Round 11mm Black Cable Clamp Filter
• 8 QTY RG316 SMA Male Right Angle to SMA Male Right Angle 24" custom here
• 1 QTY RG316 SMA Male Right Angle to SMA Male Right Angle 36" custom here + Ferrite Clamp On Cores Round 7mm USB Cable Clamp Filter
• 2 QTY RG316 MCX Male Straight to MCX Male Right Angle 34" custom here + Ferrite Clamp On Cores Round 7mm USB Cable Clamp Filter (2017: SMA to MCX)
• 1 QTY RG316 MCX Male Right Angle to MCX Male Right Angle 6" custom here (2017 only)
• 3 QTY RG316 MCX Male Right Angle to MCX Male Straight 9" custom here
• 1 QTY 1m VHDCI SCSI (SCSI-5) LVD/SE Cable - .8mm 68-pin VHDCI SCSI Male to Male + | Ferrite Clamp On Cores Round 10mm Black Cable Clamp Filter
• 1 QTY 24" 2.54mm to 2.00 mm 2-pin + Ferrite Clamp On Cores Round 7mmUSB Black Cable Clamp Filter
• 1 QTY RG316 SMB Male Right Angle to SMA Male Right Angle 36" custom here

SLAVE RX

• 2 QTY RG316 MCX Male Right Angle to MCX Male Right Angle 72" custom here + Ferrite Clamp On Cores Round 7mm USB Cable Clamp Filter

TOP_SECTION BASE PLATE

• Fan Assembly
  • 1 QTY FAN AXIAL 60X10MM VAPO 12VDC
    • 1 QTY FAN GUARD 60MM WIRE MESH NATURAL
  • 1 QTY 80X80X25 12VDC VAPO 37CFM
    • 1 QTY FAN GUARD BLND HL MNT BLACK 80MM
    • 8 QTY Ultra Soft Anti-Vibration Fan Mount

RX Grounding Connectors

• 1 QTY 12" DTACQ to RX Plate [ 14-16AWG M3 CRIMP o---o 12-10 GA 1/4 Ring Terminal ]
• 2 QTY 6" RX Plate to Connector Plate [ 12-10 AWG, #10 Ring Terminal o---o 12-10 GA 1/4 Ring Terminal ]
• 1 QTY 10" RX Plate to Door [ 12-10 GA 1/4 Ring Terminal o---o 12-10 GA 1/4 Ring Terminal ]
• 1 QTY 8" DOOR to female Bullet [ 12-10 GA 1/4 Ring Terminal o---D 12-10 Female Bullet Connector ]
• 1 QTY 8" DOOR to male Bullet [ 12-10 Male Bullet Connector D---o 12-10 GA 1/4 Ring Terminal]
• 1 QTY 20" INTERM to RX Plate 12-10 GA 1/4 Ring Terminal o---< 14-16AWG #6 Spade Terminal ] (2017 only)
• 1 QTY 4" INTERM to VICOR Plate 12-10 GA 1/4 Ring Terminal o---< 14-16AWG #6 Spade Terminal] (2017 only)

DC breaker (inside power supply/TX box)

• 1 QTY DC CIRCUIT BREAKER 6A or equivalent

Quantities for each TX BOX

PA BASE PLATE

TRACO Power Supply (on DIN RAIL)

• 1 QTY TRACO AC/DC CONVERTER 24V 600W no substitute
• 1 QTY TRACO BATT CNTRL MOD FOR TSP PWR SUPP no substitute
• 3 QTY ALUMINUM DIN CLIP 1.65"

DC Breaker

• 1 QTY DC CIRCUIT BREAKER 8A or equivalent

AC Breaker

• 1 QTY AC CIRCUIT BREAKER 6A or equivalent
• 1 QTY AC CIRCUIT BREAKER 10A or equivalent
• 1 QTY AC CIRCUIT GROUND-FAULT DIFFERENTIAL BREAKER 16A or equivalent
• 1 QTY AC surge protector 40 kA or equivalent
• 1 QTY AC LED INDICATOR or equivalent

Fan Assembly

• 1 QTY DC Fans DC Fan, 80x25mm 24VDC, Vapo, MagLev
• 1 QTY FAN GUARD BLND HL MNT BLACK 80MM
• 1 QTY RELAY GEN PURPOSE SPDT 16A 24V
• 1 QTY Gravity Mosfet Power Controller

HEATPLATE

• 1 QTY BTM00250-AlphaSA

Connector plate

• 1 QTY SMA bulkhead Female to N Female
• 2 QTY CONN RCPT MALE 4P GOLD SLDR CUP
• 1 QTY Female to Female N Bulkhead Lightning arrestor
• 1 QTY N Angle Connector

Cables and Connectors

• 1 QTY 5ft UHF (PL-259) Male cut to 14" + 10" BLACK(GREEN) connector with 12-10 GA 1/4 Ring Terminal and 10" RED with Ferrule 14AWG 0.47 Non Insulated + Ferrite Clamp On Cores Round 11mm Black Cable Clamp Filter
• 1 QTY RG316 SMA Male Right Angle to SMA Male Right Angle 42" custom here
• 1 QTY RG316 SMA Male Right Angle to SMA Male Right Angle 12" custom here
• 1 QTY RG142 SMA Male Straight to N Male Straight 24" custom here + Ferrite Clamp On Cores Round 10mm Black Cable Clamp Filter
• 1 QTY 6" RED + 5" RED 1 PC FERRULE NON-INS 10 AWG .59 ---=== 2 PCS Ferrule 14AWG 0.47 Non Insulated
• 1 QTY 6" BLACK + 5" BLACK 1 PC FERRULE NON-INS 10 AWG .59 ---=== 2 PCS Ferrule 14AWG 0.47 Non Insulated

TX Grounding Connectors

• 1 QTY 3" TOMCO to RX Plate [ 14-16AWG M3 CRIMP o---o 12-10 GA 1/4 Ring Terminal ]
• 2 QTY 6" RX Plate to Connector Plate [ 12-10 AWG, #10 Ring Terminal o---o 12-10 GA 1/4 Ring Terminal ]
• 1 QTY 10" RX Plate to Door [ 12-10 GA 1/4 Ring Terminal o---o 12-10 GA 1/4 Ring Terminal ]
• 1 QTY 8" DOOR to female Bullet [ 12-10 GA 1/4 Ring Terminal o---D 12-10 Female Bullet Connector ]
• 1 QTY 8" DOOR to male Bullet [ 12-10 Male Bullet Connector D---o 12-10 GA 1/4 Ring Terminal]

OPTIONAL PARTS

• DIN Rail Power Supplies 12W 5V 2.4A DIN-Rail
• DIN Rail Power Supplies 24W 12V 2A DIN-Rail

External cables

• POWER CABLES
  • 4 QTY CONN PLUG FMALE 4P GOLD SLDR CUP
  • 5 FT 18 AWG 2 PR SUPRA SHIELD 100ft
• 2 QTY 5 FT TYPE N MALE TO TYPE N MALE (RG213) 50 OHM COAXIAL CABLE ASSEMBLY

Tools

• CRIMP FERRULE KIT
• TOOL HAND CRIMPER for MTA 100
• HEAD ASSEM TOOL FOR MTA-100 RECP
• TOOL HAND CRIMPER 10-22AWG SIDE
• Hand Crimp Tool for Micro-Fit 3.0 Terminals, 20-30 AWG
• Hand Crimp Tool for Male and Female Crimp Terminals, 16-24 AWG Wire
• deburring Tool
• Thermal Grease / Compound
• locktite threadlocker blue
• locktite threadlocker red

NUC

• NUC i5
  • 32GB Kingston
  • 256GB SSD M.2 Samsung with OS
  • 2TB HDD Seagate